0.6 Ohms! TJet AFX Aurora triple wind armature motor arm pancake.

Description

0.6 Ohms! TJet AFX Aurora triple wind armature motor arm copper wire, red tips.
This is a triple wire custom wound pancake armature for
AFX, Aurora, TJet, or any other chassis that supports this motor.
It has been tested with silver brushes and Level 10 magnets in a new T-Jet chassis,
also tested in a 4Gear chassis
with voltage no higher than 5.5 volts.
When putting a little extra light pressure on the brush springs, the motor sounded great.
I would recommend Level 10 magnets for such a low ohm motor.
This motor spins freely.
This was re-wound with original Aurora comm plate, and original double lamination rotor.
No epoxy, or other glues were used.
I will leave all that up to your discretion to add it.
Adding epoxy or other glues will sometimes trap heat, causing premature failure.
The motor has been re-wound with new wire.
The comm plate was cleaned after testing with a non abrasive tool.
It is not balanced, and will need static and/or dynamic balancing for the best performance.
It weighs in at 3.2 grams.
Each pole measured in at 0.5, 0.6 and 0.7 respectively,
making it an overall OHM of 0.6 Ohms.
Level 10 magnets are recommended.
This is a nice wicked fast little motor.
This will be shipped in a bubble pack, and packed well.
Please handle with care.
I will combine shipping.
Please request an INVOICE if you plan on purchasing
other items so I can adjust your shipping fees.
Ships to the lower 48 for .95
Anywhere else on the planet;
please send a message for out of the
country shipping fees prior to purchase.
Thank you for your consideration.
Armature is being sold as is.
No refunds, No returns.